A10 Thunder Series 930 Installation Guide
Management Interface Configuration
Document No.: TH-930-001 - 1/26/2015
| page 22
Connection via Console (Serial Port)
1. Using the included serial cable, connect the ACOS device to a computer with terminal emulation software.
2. Power on the computer and the ACOS device. Press the ON direction of the lower rocker switch.
3. Set the terminal emulation software for 9600 baud and 8-N-1 (8 bits - no parity - 1 stop bit). Once you are connected,
the login prompt will display on the terminal.
Login via CLI
1. Log into the ACOS device with the default username
admin
and the default password
a10
.
login as:
admin
Welcome to ACOS
Using keyboard-interactive authentication.
Password:
***
[type
?
for help]
2. Enable the Privileged EXEC level by typing
enable
and pressing the Enter key. There is
no
default password to enter
Privileged EXEC mode on new systems.
ACOS>
en
Password:(just press Enter on a new system)
ACOS#
Enable the configuration mode by typing config and pressing Enter.
ACOS#
config
ACOS(config)#
It is strongly suggested that a Privileged EXEC enable password be set up as follows:
ACOS(config)#
enable-password new-password
Configure the Management Interface
This section provides instructions for configuring the management interface.
NOTE:
It is recommended to keep the management interface and the data interfaces in sepa-
rate networks. Otherwise, some operations such as pinging may have unexpected
results.
1. In the factory default configuration, the management interface has IP address 172.31.31.31/24.
2. You can use either a console connection or use another PC with an IP address in the same subnet (for example,
172.31.31.1/24), and connect the PC to the MGMT interface.
3. Configure the management interface IP address and default gateway.
Содержание Thunder series 930
