A to Z Rubber Stamps RAPIDPRINT A Series, Руководство пользователя

Страница: 101 / 122

PUSHBUTTON NUMBER ADVANCE
RETROFITTING A STANDARD AN-E MACHINE
-Drill 1/2"DIA. hole in bottom casting-location specified on diagram.
WIRING MACHINE
Wire machine per wiring diagram 08-00218-000012 and/or perform the following steps:
1-P.C. Bd must be D revision or later. If not, it must be replaced with p/n
01-07310-001129.
2-If number advance is to be controlled by pushbutton only, modify P.C. Bd by
clipping off Q4.
3-Using two Orange Wire Assemblies p/n 01-06930-000007, solder tinned ends to
Pushbutton Switch terminals.
4-Mount Pushbutton Switch by first removing one of the two hex nuts, feed shaft
of switch through hole of casting, thread Chrome Guard p/n 00-06265-000001 onto
shaft and then tighten using the remaining hex nut.
5-Attach remaining ends of orange wires to positions 2 & 6 of connector.
PUSHBUTTON STAMPING
RETROFITTING A STANDARD AN-E/AR-E MACHINE
-Drill 1/2"DIA. hole in bottom casting-location specified on diagram.
WIRING AN-E/AR-E MACHINE
Wire an AN-E machine per wiring diagram 08-00218-000004 (AR-E machine:08-00217-000003)
and/or perform the following steps:
1-Remove yellow wires from positions 7 & 9 of connector.
2-Using two Yellow Wire Assemblies p/n 01-06930-000579, solder tinned ends to
Pushbutton Switch terminals.
3-Mount Pushbutton Switch by first removing one of the two hex nuts, feed shaft of
switch through hole of casting, thread Chrome Guard p/n 00-06265-000001 onto shaft
and then tighten using the remaining hex nut.
4-Attach remaining ends of yellow wires to positions 7 & 9 of connector.
5-If both pushbutton stamping & original trigger stamping is desired, skip step 1
and splice each orange wire to a yellow wire. This can be done by using a self-
stripping splice connector p/n 00-05491-000001 (2 required).
01/04/2012 101