A-PLUS AUTOMATION A1-M-XL, Инструкция по эксплуатации

Страница: 12 / 24

12
A1-M-XL
Picture 10 Picture 11
4.8.2 Vertical clamp adjustment
The vertical clamp can be adjusted in height and position. Proceed as follows to adjust them:
4.8.2a Vertical clamp position adjustment
• Position the mouldings to be assembled on the working bench
• Select the pressure pad suitable with the profile of the moulding to
be assembled and lock it to the vertical bar
• Loosen by means of the over placed handle A (see pict.12) the
clamp that locks the pressure pad bar to allow its shifting forward or
backward up to reach the pressure pad directly in line with Wedge
inserting point.
• Tighten the handle once reached the proper position.
Picture 12
4.8.2b Vertical clamp height adjustment
• Loosen the side clamp (see pict. 13) by means of the handle and
adjust the pressure pad height over the frame (it suggested to reach
an height between 5 and 8 mm. to avoid any accidental fingers
crushing).
• Tighten the handles once reached the proper position
• Lower the vertical clamp by pressing half way the foot pedal to verify
that the mouldings to be assembled are properly locked
• Press full down the foot pedal to insert the Wedge.
Picture 13
A
A
B