A-PLUS AUTOMATION A1-M-XL, Инструкция по эксплуатации

Страница: 11 / 24

11
A1-M-XL
4.7.2 Nail guide head replacement to change Wedges size
The nail guide head must be changed each time you use Wedges of different sizes.
Proceed as follows to replace it:
• Loosen the locking screw of the Wedge guide head us-
ing the proper 5 mm Allen wrench (the screw is on the
opposite side from the Wedges magazine(See pict. 7)
• Take out the Wedge guide head
• Move backward the claw pusher by pulling backward the
nylon thread and making accessible the Wedges magazine
(see pict. 4).
• Remove all the Wedges that are still in the magazine (us-
ing the proper brass magnet, if necessary - see pict. 8).
• Insert the new Wedge stick (of desired size) into the
magazine.
• Move forward the claw pusher by by releasing the nylon
thread (see Picture 7).
• Insert the new size Wedge guide head to match the
Wedges to be used (see pict. 8).
• Tighten the locking screw of the Wedge guide head (see
pict.7).
Picture 7
Picture 8
Picture 9
4.8 ADJUSTMENTS
Being the machine completely tested and checked in A-Plus Automation’s plants before its shipment, the operator
has only to effect the following adjustments:
4.8.1 Wedges inserting positions adjustment
To position properly the mouldings to be assembled, the machine is equipped with a 90° fence.
The fence can be shifted forward or backward in order to allow the proper positioning of mouldings of several sizes.
The fence limits (backward and forward) can be set with precision by means of locking clamps A-B (see pict. 10).
So the operator can easily use the machine to insert Wedges with extreme precision into 2 different positions
(pict. 11).