A.O. Smith BTI - 65, Инструкция по установке и эксплуатации

Страница: 12 / 26

12
2. FOR THE InsTALLER
2.1 Installation instructions
This water heater must be fitted in a
location which will permit the provision
os an approved flue system and
adequate ventilation.
A service clearance of 15 cm at the sides
and rear of the unit and 60 cm at the front
of the unit should be allowed for ease of
servicing. Adequate distance must be
allowed between the top of the unit and
any obstruction or ceiling to allow the flue
baffle and anode to be inspected, cleaned
or in the case of the anode replaced if
necessary.
The water heater must stand on a level
surface resistant to heat, insulted in
accordance with local bylaws and Building
Regulations 1985, with sufficient strength
to support the weight of the unit when full
of water.
This water heater must not be installed
in a bathroom, bedroom or in a cupboard
opening on to such rooms. This water
heater must not be installed in any area
where flamable materials are used or
stored.
Insufficient ventilation may give rise to
a risk of fire, explosion or suffocation. If
in doubt consult the national and local
regulations governing the installation of
gas appliances or your British gas sevice
department.
2.1.1 Installation
The installation of this water heater should
be carried out by a suitably qualified
competent person. It is a criminal offence
for unqualified persons to install gas
equipment.
Installation should be carried out in
accordance with all local authority and
Building Regualions, Model Water Bylaws,
bylaws of the local water supplier, Building
Standards (Scotland) (Consolidation)
Regulations and any relevant requirements
of the Local Authority, local gas regions
and the following British Standards (current
editions):
For domestic applications:
BS 5440 - part 1 and part 2.
BS 5546 - Installation of gas hot
water supplies for domestic
purposes.
BS 6700 - Specifications for design,
installation and maintenance
of services supplying water
for domestic use within
buildings and their curtilages.
BS 6798 - Specification for installation
of gas fired hot water boilers
of rated input not exceeding
60 kW.
BS 6891 - Specification for installation
of low pressure gas pipework
of up to 28 mm in domestic
premises.
For non-domestic applications:
BS 5400 - part 1 and part 2.
BS 6798 - Specification for installation
of low pressure gas pipework
of up to 28 mm in domestic
premises.
CP 342 - Code of practice for
centralised hot water supply
part 2, buildings other than
individual dwellings and the
following additional Codes of
Practice.
IM/2 - Purging procedures for non-
domestic gas installations.
IM/5 - Soundness testing
procedures for industrial and
commercial gas installations.
IM/11 - Flues for commercial and
industrial gas fired boilers
and air heaters.
IM/16 - Notes on installation of
pipework (excluding 25 mm
and below).
Some chemicals produce vapours which
can cause rapid failure of main- and
pilotburners and storage tanks if they are
drawn into the combustion air supply.