4RF Aprisa SR+, Руководство пользователя

Страница: 12 / 12

12 | Default Configurations
Aprisa SR+ Demo Kit Guide 1.3.0
Layer 2 Filter
Layer 2 Filter enabled
Layer 2 Filter Rules Source
MAC Address
Destination
MAC Address
Protocol Type
Allow ARPS FF:FF:FF:FF:FF:FF FF:FF:FF:FF:FF:FF ARP
Allow Unicasts from ANY source FF:FF:FF:FF:FF:FF FE:FF:FF:FF:FF:FF ANY
Moxa RTU
The RTU has been preconfigured to the requirements of this demo kit. However, should the settings be
changed in any way, the parameters can be re-configured by following these steps:
The factory default IP address of the RTU (MOXA ilogik E2124) is 192.168.127.254
1. Open Web browser and enter: 192.168.127.254
2. Navigate to Network Settings > Ethernet Configuration
a. Set the IP address to: 172.17.200.220
b. Set the subnet mask to: 255.255.0.0
c. Set the gateway to: 0.0.0.0
3. Navigate to I/O Settings > D0 Channel Settings
a. Configure D0 channel 3 to Power Settings “ON”
Laptop
Network Connections Terminal Emulator
Local Area Connection COM Port Settings
Properties BaudRate 38400
Internet Protocol TCP/IP Settings Data 8 bit
IP Address 172.17.200.110 Parity None
Subnet Mask 255.255.0.0 Stop 1 bit
Default Gateway 0.0.0.0
(none)
Flow Control None
Advanced TCP/IP Settings Terminal Settings
WNS Disable NetBIOS over TCP/IP ASCII Receiving CR+LF
(line feed after receiving a text file)
Wireless Network Connection Disable Character delay 0
Line delay 0