4qd PRO-160 Series, Инструкция по эксплуатации

Страница: 2 / 16

PRO-160 V2.0 10/19 Page 2 www.4qd.co.uk
1. Introduction
The Pro-160 is an advanced digital PWM motor controller for currents up to 200A.
It uses a specialist microprocessor to control a full H-bridge design that does not
require relays for reversing. The display provides key information to the operator,
and can be mounted separately to the controller if required. It has a full range of
features and is very easy to configure if required.
2. Do's and D
on’ts
Warning
– the Pro-160 does not have reverse polarity protection.
Connecting the battery wires incorrectly WILL destroy the controller.
Do

Do r ead the instructions fully
before installing.

Do take care to connect the
battery wires with the correct
polarity

Do fit a motor suppression
capacitor, and ferrite rings.

Do twist the motor wires
together if possible.

Do call 4QD if you are
uncertain about something
Do not

Do not allow water to enter
the box.
3. Getting Started

First remove the four screws that hold the cover to the end plates and lift off
the cover.

The Pro-160 is supplied with the keymat ribbon cable not connected to its
socket. We recommend only plugging this in once the Pro-160 has been
fixed in position, the control and power connections made, and you are
ready to start operation.