4Ddoors CX1024, Инструкция по установке, эксплуатации и обслуживанию

Страница: 9 / 42

ENGLISH 9
4.2.5 Installing the opener housing
• Remove the 4 nuts (D) and washers (E) used to fi x the base
plate to the ground anchors during foundation works.
• Cut the empty conduit seal (F) according to the connection
lines and install in the opener housing. Ensure that the holes
are not too large that insects may be able to crawl through.
• When positioning the housing on the fl oor anchors or on the
threaded rods of the heavy load anchor, pull the supply line
and other connection lines through the empty conduit seal into
the housing from below, ensuring that there is no warping.
• Position the opener on the threaded bolts of the base plate,
align parallel to the gate and adjust the height using the
4 height adjustment screws (G). Then fi x the opener motor.
G
E
D
F
4
Figure 4 - Fixing
Note
When tightening, ensure a level, stable and secure fi xing.
A minimum clearance of 5 mm between the anti-trap protection
and gate panel must be adhered to over the entire length of the
gate, see
“Figure 5 - Aligning the opener”
.
5
> 5 mm
D
97 mm
2 mm
0 - 20 mm
Figure 5 - Aligning the opener
4.3 Gear rack installation
Note
Unlock the sliding opener before installing the gear racks, see
“Figure 8 - Unlocking the opener”
.
• Using the height adjuster, raise the opener by approx. 5 mm
and fi x the motor to the base plate.
• Unlock the opener.
• Rest the gear rack against the opener pinion and by sliding
the gate manually, install the gear rack metre by metre to the
gate. Fix the gate rack in alignment with the opener pinion.
• Adjust the opener using the height adjustment screws (G) so
that there is gap of 1 - 2 mm between the rack and pinion. This
prevents the weight of the gate from exerting a load on the
opener.