PS1005G-1GT-4PoE User Manual
5
Chapter 3 Installing and Connecting the Switch
This part describes how to install your Ethernet Switch and make connections to it.
Please read the following topics and perform the procedures in the order being presented.
3.1 Installation
Please follow the following instructions in avoid of device damage and security threat
because of the incorrect installation.
Put the Switch on stable place or desktop in case of falling damage.
Make sure the Switch works in the proper DC input range and matches the voltage
labeled on the Switch.
Please keep the Switch away from electric spark, do not open the Switch’s shell even
in case of power failure.
To ensure that there is enough space for heat exchange ventilation for the Switch.
Make sure the cabinet is strong enough to support the weight of the Switch and its
accessories.
3.1.1 Desktop Installation
User can put the Switch on the stable desktop, close to the power adapter. Make sure
there is enough space for heat exchange ventilation for the Switch.
3.1.2 Rack-mountable Installation
Two slots are provided at the bottom of the Switch, which can be used to fasten the
Switch on the wall. Please ensure that the Switch’s front panel is on top, for easy checking
the LED indicators. Please follow the steps below:
a. Before installing, attach the two screws to the wall for installation.
b. Then hang the Switch at the two screws.
3.1.3 Power on the Switch
The Switch is powered on by an external power supply. Please follow the tips to
connect.
DC Electrical Outlet:
Receptacle with neutral outlet or multifunctional computer
professional receptacle is strongly recommended. Please confirm that the ground
connector is in good condition and can work properly on the outlet.
DC Power Cord Connection:
Connect the DC power connector in the back panel of the
Switch to external receptacle with the included power cord, and check the power indicator
is ON or OFF. When it is ON, it indicates the power connection is OK.
