User manual
20
www.3onedata.com
In the menu bar in order to click on the "main menu", "system configuration", "diagnostic ", "Ping", enter
the Ping interface.
(Figure 6.2.8.1)
Ping configuration steps:
Step 1: in the IP address text box to fill in the need for IP Ping address;
Step 2: click on the "test" to see the results of the ping.
6.2.8.2 Traceroute
Traceroute to measure the length of time it takes to send a small packet to the destination device until it
returns. A path on each device traceroute to be measured 3 times. The output results include the time for
each test (MS) and the name of the device (if any) and its IP address.
In the menu bar in order to click on the "main menu", "system configuration", "diagnostic", "traceroute",
enter the traceroute interface.
(Figure 6.2.6.2)
Traceroute configuration steps:
Step 1: fill in the destination IP address in the IP address text box;
Step 2: click "test" to see the results.
6.2.8.3 Port loopback
Port loopback is a common method for the maintenance and troubleshooting communication port line.
The receiving end of the test equipment or line is Short circuit with the sending end, so that the device can
receive the signal from the signal to judge whether there is a breakpoint on the line or port. The
transmission quality of the loop circuit can also be tested by hanging the test instrument on the loop
circuit.
In the menu bar, click on the "main menu", "system configuration", "diagnostic ", " Port loopback ", enter
the port loop configuration interface.