CLI user manual
31
{1|2|3|4}
1 --Enable SW-Ring I
2 --Enable SW-Ring II
3 --Enable SW-Ring III
4 -- Enable Rstp
Switch(Ring)#
Enable 3
[OK]
Tip: This configuration will be validated after restarting
Switch(Ring)#
config ring3 1 1 1 7,8 0
[OK]
Tip: This configuration will be validated after restarting
Example: to modify the first groups in SWRing3 ring network ports 5, 6
Switch(Ring)#
modify 1 -p 5,6
[OK]
Tip: This configuration will be validated after restarting
9.7
The RSTP configuration
RSTP enabled, can use the following command to set the RSTP.
Table 9.7.1 RSTP to set and modify.
Operating
Command
Description
The
configuration
of RSTP
Config rstp_state
<priority><hellotime> <delaytime>
<maxage>
<priority> --RSTP priority
{0|4096|8192|12288|16384|20480
|24576|28672|32768|36864|40960|
45056|49152|53248|57344|61440}
<hellotime> --RSTP hellotime Range
[1-10]s
<delaytime> --RSTP delaytime Range
[4-30]s
<maxage> --RSTP maxage Range
[6-40]s