3onedata IES618 Series, Руководство пользователя CLI, Страница: 20 / 49

CLI user manual
15
3.4 To enable or disable the port
The user can use the following command to open or close the port. By default, the port is
enabled.
Table 3.4.1 to enable or disable the port:
Table 3.4.1
Operating Command Description
Enable port
switch <portlist>
{enable|disable}
<portlist>: 1, 3, 5-8 or all
Example: 3, 4, 6 closed port
Switch
（
Port
）
# switch 3,4,6 disable
[OK]
3.5 Configure the port speed and duplex mode
Table 3.5.1 configure the port speed and duplex.
Table 3.5.1
Operating Command Description
Configure the
port speed
and duplex
mode
Mode <portlist> {10h|10f|100h|100f|auto}
<portlist>: 1,3,5-8 or all
mode:
10h, 10Mbps Half duplex
10f, 10Mbps Full duplex
100h, 100Mbps Half duplex
100f, 100Mbps Full duplex
Auto: Automated negotiation
Example: Rate of 3, 4, 5 100Mbps full duplex port configuration
Switch
（
Port
）
# Mode 3-5 100f
[OK]
3.6 Configure the port flow control
Table 3.6.1 to enable or disable the port flow control:
Table 3.6.1
Operating Command Description
Enable port flow control Flow-con <portlist> enable <portlist>: 1,3,5-8 or all
Disable port flow control Flow-con <portlist> disable <portlist>: 1,3,5-8 or all
Example: open port 3, 4, 5 flow control
Switch
（
Port
）
# flow-con 3,4,5 enable
[OK]