background image

Quick Installation Guide

Printer overview

Printer Installation

Button functions

Loading the label

Feed button

Top cover open lever

Note: 

The interface picture in the quick start guide is for reference only. Please

 refer to the product specification for the interfaces availability.

1.Insert a 1" label spindle into a paper roll (* If your paper core is 1''inch, remove 
   the 1.5''  core adapter from the fixed tab).

2

.

Open the printer top cover by pushing 

   forward the top cover open levers.

(1)Feed labels

When the printer is ready, press the button to feed one label to the beginning of next label. 

(2)Pause the printing job

When the printer is printing, press the button to pause a print job. When the printer is 
paused the LED will blink green. Press the button again to continue the printing job.

3.Orient a roll of paper on the paper roll mount.
4.Feed the paper, printing side face  up, through 
   the label guide and pass  over the platen.
5.Adjust the black center-biasde label guides in 
or out turning adjustment knob so they are 
slightly touch the edges of the label backing. 

6.Close the printer top cover slowly and make sure 
   the cover locks latch securely.
7.Use the “Diagnostic tool” to set the media sensor type 
   and calibrate the selected sensor. (See “Diagnostic
   tool” and “Sensor Calibrate” in the next page). 

Note:

1. Please calibrate the gap/black mark sensor when changing media.
2. Failure to securely close and lock the cover will result in
    poor print quality.

Note: 

Please switch OFF printer power switch prior to 

plug in the power cord to printer power jack.

1.5'' Core Adaptor

 1"label spindle

01

02

Top cover open lever

Fix Tab

Paper Roll 

LED indicator

USB interface

MicroSD slot

Ethernet interface

RS-232 

Power jack

Power jack

Power supply

Power plug

power switch

Rear paper guide

Printer top cover

Paper roll mount

Label guide

1.Arrange this printer on a reliable flat surface and make sure the power switch is off.
2.Connect the printer to a computer mainframe with a provided Centronics,RS-232 or 
USB cable.
3.Plug the power cord into the power jack
   connector  at the rear of the printer, then plug 
   the power cord  into a properly grounded outlet.

Adjustment knob

Printing side

 

face up

Отзывы: