3M LM1, Руководство пользователя

Страница: 27 / 33

25
EN
(English)
XIV. PERFORMING ADMINISTRATIVE TASKS
a.
Setting the Date, Time and Time zone on the 3M ™ Clean
‑
Trace ™ Luminometer
If connected on Wi-Fi with Internet access, date and time on the 3M Clean-Trace LM1 Luminometer will be set or
adjusted automatically using Network Time Protocol (NTP),
if “ Automatic date & time ” is checked in the 3M Clean-
Trace LM1 settings.
b.
How to adjust the date/time on the 3M ™ Clean-Trace ™ LM1 Luminometer
1. Double tap the top of the Luminometer display. This will open the “ General settings ” screen as shown below.
2. Tap on the t ime to open the “ Date & time settings ” screen.
3. In the “ Date & time settings ” screen, make sure the “ Automatic date & time ” is unchecked.
4. Tap [ Set date] , tap on a section of the date (E.g., Month, Day, Year) and use to adjust/set the date,
then tap [ Done] at the bottom.
5. Tap [ Set time] tap on a section of the time (E.g., Hour, Minute) and use to adjust/set the time,
then tap [ Done] at the bottom.
6. Tap [<] at the top left of the “ Date & time settings ” screen to return to the 3M Clean-Trace application
screen.
1
Users are advised to check and confirm the Date, Time, and Time zone on the 3M
Clean-Trace LM1 Luminometer:
▪
Prior to the first use
▪
Every time the unit returns from the 3M Service
▪
After an extended period of storage (when the unit has been unused)
All test results are time-stamped with Luminometer date and time, which could not be
changed after data collection.
4
5
3