4
SEITE 4 - 148 x 210 mm - 086/0/-/51+ F -
SCHWARZ
- 03-0132 (sr)
must be replaced after 9999 illumination cycles (see
“Malfunction”).
Replacement of the upper pair of lamps
(inside the cover of the polymerization chamber)
Open the polymerization chamber by pressing the “Lid”
button.
Turn the unit off and pull the power plug from its socket!
Unscrew the six screws
located in the cover
plate, and remove both
the cover plate and
glass plate.
Clean both sides of the
glass plate with a cloth
dampened in alcohol.
Remove the two lamps
from their respective
holders by pulling in an
upward direction. If the reflector located behind the lamps
is contaminated, clean it with a cloth dampened in alcohol.
Caution: Do not scratch the reflector with any hard objects!
Place new fluorescent lamps LB 1 in the respective holders.
Replace the cover plate and fix in place by tightening the
six screws.
Replacement of the lower pair of lamps
Empty the polymerization
chamber and close the lid.
Turn the unit off
and pull the
power plug
from its socket!
Place the unit
on its right side.
Unscrew the screw located in the bottom door and remove
the door.
Remove the two
fluorescent lamps from
their respective holders
by pulling in an upward
direction.
Clean the bottom door
reflector and the bottom
side of the glass cup with a
cloth dampened in alcohol.
Caution: Do not scratch the reflector with any hard objects!
Place new fluorescent lamps LB 1 in the respective holders.
Attach bottom door by its hinges, close the door and
tighten the screw.
8. Care of the unit
Clean the unit with a commercial dish-washing detergent.
(Organic) Solvents may damage the housing of the unit.
Date of the information: 02/03
Any contamination inside the polymerization chamber
should be removed with alcohol. Persistent contaminating
material should be soaked by placing an alcohol-saturated
piece of cloth inside the chamber and closing the cover.
(Do not press the Start-Stopp button.) After extended
soaking (preferably over night) use a plastic spatula to
remove residues of the working materials from the
polymerization chamber and glass plate. Do not use a
metal instrument for this purpose!
Fluorescent lamps must be cleaned/dusted at least at
semi-annual intervals to ensure proper performance of the
lamps. For details on how to clean reflectors and fluorescent
lamps, please refer to the section on “Replacement of
upper/lower pair of lamps”.
9. Storage / transport
Do not store Visio Beta vario below -10°C/24°F or above
+ 60°C/140°F.
10. Customer Information
No person is authorized to provide any information which
deviates from the information provided in this instruction
sheet.
Warranty
3M ESPE warrants this product will be free from defects in
material and manufacture. 3M ESPE MAKES NO OTHER
WARRANTIES INCLUDING ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE. User is responsible for determining the suitability
of the product for user’s application. If this product is
defective within the warranty period, your exclusive remedy
and 3M ESPE’s sole obligation shall be repair or replace-
ment of the 3M ESPE product.
Limitation of Liability
Except where prohibited by law, 3M ESPE will not be liable
for any loss or damage arising from this product, whether
direct, indirect, special, incidental or consequential,
regardless of the theory asserted, including warranty,
contract, negligence or strict liability.