3D Systems sPro, Руководство пользователя, Страница: 97 / 280

SLS p r o c e s s 9 7 B R E A K O U T P A R T S
u s e r ’ s g u i d e b r e a k o u t p a r t s f r o m p a r t c a k e
B re a ko u t Pa r t s f r o m Pa r t Ca ke
Raise the part piston and allow powder to fall
away from the part as the part cake rises.
As you raise the piston, remove surrounding
powder from the outline of the parts with a
spatula and brush. Brush unsintered part cake
powder into the power transport hopper through
the grate.
When you can easily grasp a part, carefully lift it.
In the case of a tall single part, you may need to
tilt it to clear the top of the process chamber.
Gently brush off the parts and place them on the
part BOS work table or separate tray.
The part cake can remain extremely
hot for hours after a build. To prevent
burns, allow sufficient time for cool
down (up to 24 hours) before
removing the part cake.