3D Systems sPro, Руководство пользователя

Страница: 46 / 280

SLS p r o c e s s 4 6 S L S P R O C E S S
u s e r ’ s g u i d e S L S p r o c e s s o v e r v i e w
➎
Build...
parts in the SLS system. First you dock the
clean (optionally preheated) RCM in the SLS
system, run the
Sinter application from the
SLS system console, load the RCM, then
choose the build packet you want to build in
Sinter .
After you start your build, the SLS system
warms up and inerts the
process chamber .
Then a roller spreads a thin layer of powder
across the heated powder bed in the process
chamber . A laser beam scans one or several
part cross sections on the layer, fusing
powder along the
scanning path. The many
(possibly thousands) of consecutive layers of
fused cross sections form one or more 3-D
SLS parts.
See Running a Build , as well as the Material Guide
for the material you are using. Also see your Sinter
application online Help .
➏
Breakout...
parts from the part cake using the BOS . But
you must wait for the part cake cooldown to
finish. Your controlled cooldown can take
place at the end of the build inside the SLS
system, or, you can remove the RCM while it’s
still warm
.
After the part cake is cool enough
to handle, you dock the RCM in the BOS, raise
the part cake, then breakout the parts from
the part
cake. As you remove used part cake powder
during breakout, you can use the BOS to
automatically sift and either recycle or
dispose of it. All that remains after breakout is
to fine-clean and optionally finish coat your
parts.
➐
Voilà !...
Here are your parts!