3D Systems sPro, Руководство пользователя

Страница: 34 / 280

SLS p r o c e s s 3 4 S A F E T Y
u s e r ’ s g u i d e m e c h a n i c a l m o t i o n h a z a r d l o c a t i o n s
M e c h a n i c a l M o t i o n H a z a r d L o c at i o n s
You should be aware of the following pinch,
crush, and rotating blade hazard locations
on the SLS equipment:
BOS door The BOS door is hinged at the top
with props on the left and right sides to help
you safely raise and lower it. To avoid injury,
always follow these precautions when
opening and closing the BOS door:
✓
Warn anyone near the BOS before you
open or close the door.
✓
Open and close the door with both
hands on the handle.
✓
Fully open or close the door. Do not
leave it partially open or closed.
✓
Keep hands away from the door props
on the right and left sides of the door.
✓
Make sure anyone working near the BOS
has their hands clear of the door before
you open or close it.
BOS powder transport hopper Do not
operate the BOS with the powder transport
hopper grate off. Disconnect power to the
BOS before you remove the grate.
RCM docking Keep you hands away from the
front and sides RCM when you dock it in the SLS
system or BOS.
BOS RCM seal Always clip the hinged BOS RCM
seal in its up position before docking the RCM.
Keep hands
away from
BOS door
side props
and hinges
Use both hands on handle when
opening BOS door.
Keep hands off BOS table top
when closing door.
Keep hands
away from
the front
and sides of
the RCM
when
docking
Keep protective
grate on top of
(and hands out of )
the BOS powder
transport hopper