3D Systems sPro, Руководство пользователя

Страница: 250 / 280

SLS p r o c e s s 2 5 0 G L O S S A R Y
u s e r ’ s g u i d e
D
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Cooldown stage The third
of three SLS® system
build stages. The build
profile for the
unscanned layers added
after the last scanned
Build stage layer.
configuration file
See material configuration file .
contactor An electro-mechanical power relay.
The SLS® system machine contains several
contactors.
Cross Fill Scan An advanced part profile
parameter that alternates the scanning
direction between X and Y every layer. You
must purchase a
Sinterscan license to use this
parameter.
curl an SLS part defect; part warping due to
uneven heating or cooling. There are two
types of curl: “in-
build curl” and “post- build
curl.” In- build curl happens when the hot
laser beam hits a cold (or insufficiently
preheated) part bed . Post- build curl happens
when different regions of a part cool down at
different rates. Controlled cooldown helps
prevent post-build curl.
curling
See part curling .
cylinder
See part cylinder .
D
damper The hinged metal plate below the laser
window at the top of the process chamber
beam shaft. When closed, it blocks the laser
beam from entering the process chamber ,
and helps keep powder out of the IPM .
default Response or
conditions used by a
computer unless the
user commands it to use
something else.
dependency
In the
SLS® system , a condition
that must be met before
a command can be
executed.
See also
Build stage and
Warmup stage
Always close the damper lever on
the front of the IPM
before you
remove the laser window for
cleaning—and before you open
any door or panel on the
SLS® system. Open the damper
before you start a build.
See also Default
Values and
Dependencies
topic in
Sinter
Help
See also Default
Values and
Dependencies
topic in
Sinter
Help