3D Systems sPro, Руководство пользователя

Страница: 163 / 280

SLS p r o c e s s 1 6 3 I R S & I P C
u s e r ’ s g u i d e l o a d i n g v i r g i n p o w d e r i n t h e I R S
Lo a d i n g Vi r g i n Powd e r i n t h e I R S
To load virgin powder into the IRS Virgin bin , do
the following three steps:
1
Connect a full (or partially full) IPC to the IRS
2
Put the IRS in Ready mode.
3
Change the IPC status from Do not Unload to
Unload .
Each of these three loading steps are detailed
below. When loading is done, Press
to exit
Standby and enter Ready mode.
L
To ensure your builds never run out of powder,
always replace an empty IPC with a full one as
soon as possible.
Step 1: Connect a full (or partially full) IPC
to the IRS
1
Use a pallet jack or forklift to move a full (or
partially full) IPC within 3 m (10 ft) of the right
side of the IRS.
2
If an empty IPC is currently connected,
reverse Steps 3 and 4 below to disconnect it,
then move it out of the way.
3
Connect the pulse air line on the IRS umbilical
to the full IPC’s pulse air inlet on the front of
the IPC pallet.
To ensure a good seal, press the lock button
on top of the pulse air connector, push the
connector onto the inlet, then release the
button.
IRS
umbilical
pulse air
line
connector
IPC pulse
air inlet