3D Systems ProX DMP 200, Руководство пользователя

Страница: 40 / 103

36 3D SYSTEMS, INC .
Step 1 : Initialization
For each new job preparation, the printer must be initialized at first. The Initialization step is performed automatically:
1. Click on the automatic cycle launch button (1).
2. When automatic cycle completed, click on
Next (2) to go to the next step.
Step 2 : Plate unloading
NOTE: if there is no sintering plate to unload, the step 2
is not to be performed. In this case, confirm the pop-up
message to go directly to the next step .
The Plate unloading step includes both automatic and manual actions. When automatic actions have been done, manual
actions are required.
1. Click on the Start button (1): this will launch the automatic cycle.
2. When the automatic cycle is completed, then perform the actions (2) by using the available commands (3) and the
external control panel. Consult the section "Unloading a plate" on page 65 for details.
3. When manual actions completed, click on Next (4) to go to the next step.
1
2
1
3
2
4