31
U
SING
THE
P
RE
-IP C
ONFIGURATION
W
IZARD
You can only configure devices that are on the same subnet as your computer. To
configure a device on a different subnet, you must first assign it an IP address on
the same subnet as your computer. After you launch the configuration, you can
change settings as usual. Just before you finish, you must change the device IP
address back to its original setting. Follow this procedure:
1
In the Wireless Infrastructure Device Pre-IP Configuration window, accept the
suggested settings or change them as required. You can assign a static IP
address or specify that the device obtain its IP address from a DHCP server.
2
The next window prompts for an administrative password. When the units
are shipped from the factory, there is no administration password and you
should leave the password field blank. If an administration password has
been set for the device, enter the password and click
Next
. The Configuration
Management System main page appears in the Web browser.
C
ONFIGURATION
L
OGIN
After you launch the configuration from the device manager, the login page
appears in your browser.
The default username is: admin
The default password is: no password
For an initial configuration, enter the default username and click
LOGIN.
Then set
the Country Code as described below.
S
ETTING
THE
C
OUNTRY
C
ODE
The Country Code determines the available channels and transmission power
level based on regulatory restrictions in the country where the access point is
installed. The first time you log in, you must set the Country Code.
To ensure compliance with local regulations, be sure to select the country in
which the access point is installed.
In the Country Code page, select the country from the pull-down list and click
Apply.
The configuration interface Home page appears.
