1-18
As for the
dot1x version-user
command, if you execute it in system view without specifying the
interface-list
argument, the command applies to all ports. You can also execute this command in port
view. In this case, this command applies to the current port only and the
interface-list
argument is not
needed.
Enabling DHCP-triggered Authentication
After performing the following configuration, 802.1x allows running DHCP on access users, and users
are authenticated when they apply for dynamic IP addresses through DHCP.
Follow these steps to enable DHCP-triggered authentication:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enable DHCP-triggered
authentication
dot1x dhcp-launch
Required
By default, DHCP-triggered
authentication is disabled.
Configuring Guest VLAN
Follow these steps to configure guest VLAN:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Configure the access control
method of ports
dot1x
port-method
portbased
Required
The default access control
method on a port is
MAC-based. That is, the
macbased
keyword is used by
default.
In system
view
dot1x guest-vlan
vlan-id
[
interface
interface-list
]
interface interface-type
interface-number
dot1x guest-vlan vlan-id
Enable the
guest VLAN
function
In port view
quit
Required
By default, the guest VLAN
function is disabled.
Содержание Switch 4800G PWR 24-Port
