3Com SuperStack II 3300, Руководство пользователя

Страница: 92 / 172

92 C
HAPTER
8: S
ETTING
IP P
ARAMETERS
Setting the Mode You can set the OSPF mode for each interface. The mode can be enabled
or disabled. You must set the mode to enabled to run OSPF routing.
The default mode is disabled.
To set the mode for the interface:
1 Enter the following at the top-level menu:
ip ospf interface mode
The following prompt is displayed:
Select IP interfaces (1-3|all) [1]:
2 Select the index number(s) representing the interface(s).
Enter OSPF mode {disabled,enabled} [enabled]:
3 Enable or disable the OSPF mode for each interface as required.
Setting the Priority The interface priority is a value that you assign to an OSPF router to
determine its status as a designated router. A router can function in one
of three ways:
■
Designated router (DR) — The router with the highest priority value
is always the designated router, unless a designated router already
exists on the subnetwork.
■
Backup designated router (BDR) — A router with a lower priority
value.
■
Not a designated router — A router with a priority value of 0.
mismatchHello Number of hello packet interval mismatches detected
mismatchDead Number of router dead interval mismatches detected
mismatchMask Number of subnet mask mismatches detected
mismatchAreaID Number of interface area ID mismatches detected
mismatchAreaType Number of interface area type mismatches detected
receivedUnknown Number of unknown LSAs received
authError Number of authentication errors
packetXsum Number of packet checksum errors since interface has come up
lsaXsumError Number of LSA checksum errors detected
Table 21 Field Attributes for Interface Statistics Display (continued)
Field Description