3Com CoreBuilder 9000, Руководство пользователя

Страница: 190 / 468

190 C
HAPTER
7: C
ONFIGURING
V
IRTUAL
C
HANNELS
Update Signaling
Protocol Profile
Update the signaling protocol profile for the selected port. See the
previous section for details. This command causes the new Signaling
Protocol Parameters to be activated in the current session, and the new
value is stored in flash. If a new value is not entered and stored in flash,
the ATM Enterprise Switch reverts to the previous value of the Signaling
Protocol Parameters the next time that it reboots.
Command Actions
Command Result
Example
Enter:
1 1 4 5 2 3.1.2 1
The following message is displayed:
This operation will release all connections of the specified
port(s)!
Are you sure (Y/N)?
Enter
Y
to confirm,
N
to cancel.
The following message is displayed:
The profile was set successfully.
The signaling protocol for port 3.1.2 is updated to Network and saved.
Enter the menu sequence:
(1) SYS: Platform configuration
(1) SET: Switch setup
(4) SIG: Signaling setup
(5) SPS: Signaling protocol
configuration setup
(2) SPR: Set profile of port
Enter a parameter at the prompt
Parameter Format or Range
Port number <slot.group.port>; Enter
0.0
for all ports
Signaling profile
0
for user profile
1
for network profile
Direct access sequence:
1 1 4 5 2
[parameters]
System action taken: The signaling protocol profile is updated. for the
specified port.
System message display:
Parameter was successfully set