3Com CoreBuilder 3500, Руководство по внедрению

Страница: 392 / 592

392 C
HAPTER
14: O
PEN
S
HORTEST
P
ATH
F
IRST
(OSPF)
Neighbors
Neighbor routers are those that are physically attached to the same
network segment. The OSPF Hello protocol establishes adjacencies
among neighboring routers to facilitate the exchange of routing
information. An
adjacency
describes the relationship between two
routers that exchange network topology information. A router attached
to multiple network segments may have different sets of neighbors on
each segment.
For example, Figure 70 earlier in this chapter includes several sets of OSPF
neighbor routers. In backbone area 0:
■
Routers 2 and 3 and area border routers 1 and 3 are neighbors on
segment 1 (the backbone network).
■
Routers 1 and 2 are neighbors on a point-to-point link.
■
Routers 3 and 4 and area border router 2 are neighbors on segment 4.
■
No routers are neighbors on segments 2, 3, 5, and 6.
In area 1:
■
Router 5 and area border router 2 are neighbors on segment 7.
■
Routers 5 and 6, area border router 4, and autonomous system
boundary router 1 are neighbors on segment 9.
■
No routers are neighbors on segment 8.
In area 3, area border routers 3 and 4 are neighbors on a virtual link
between the backbone area 0 and area 1.
Neighbor Information Your system can display a list of all neighbors for all OSPF interfaces
defined on the system. The list includes the following information:
■
Index — The Index number that corresponds to the OSPF router
interface for which neighbors have been discovered.
■
Neighbor Address — The IP address of the neighboring router.
■
Router ID — The router ID of the neighboring router.