30
C
HAPTER
4: I
NSTALLING
AND
C
ONFIGURING
IN
N
ET
W
ARE
Install Server Features
Two drivers are associated with Dynamic
Access
technology server features under
NetWare: SE and LBRSL.
1
From the Configuration Options screen select
Product options
.
2
Select
Install a product not listed
.
The following message appears:
Product will be installed from A:\. If you are installing
from floppy, insert the first diskette of the product you
want to install into the drive and verify that the path
above is correct.
Press <F3> to specify a different path;
Press <ENTER> to continue.
3
Press F3.
4
Enter this path:
ecd210p980x:\nwserver
The following message appears:
Product “3Com DynamicAccess Server Features” was found.
Verify that this is the product you want to install before
proceeding.
Press <ENTER> to continue.
Press <ESC> to abort installation.
5
Press Enter.
The system copies the Dynamic
Access
technology server features software to the
SYS volume.
Configure Groups
1
Press Esc to return to the Installation Options screen.
2
From the Configuration Options screen, select
NCF files options (create/edit server
startup files)
3
Select
Edit AUTOEXEC.NCF file
.
4
Make the following changes to the AUTOEXEC.NCF file:
■
Add a command to load the SE and LBRSL drivers before any commands to
load LAN drivers. For example:
load se
load lbrsl
■
Add or verify the LOAD commands for the LAN drivers for all slot-frame
instances.
■
For each Load Balancing/RSL group, load the same protocols and frame
types on the primary and all secondary NICs.
■
On the primary NIC only, bind a protocol to each slot-frame instance.
■
Remove any protocol BIND commands from each secondary NIC.
