3-2
C
hapter
3: C
onfiguring
the
A
dapter
If you have a non-NetWare network environment, see the
section "Non-NetWare Environments" later in this chapter.
For other adapter configuration situations, see one of the
following sections:
■ Configuring Multiple Adapters
■ Configuring the Adapter for an EISA Computer
■ Reconfiguring the Adapter for an ISA Computer
few
For information on using command line commands to
configure the adapter, press [F I] to access the Help screen.
Using th e A u to L in k Program
To use the AutoLink program to configure a single
EtherLink III adapter, follow the steps below. If you have more
than one EtherLink III adapter in your computer, see the
section "Configuring Multiple Adapters" later in this chapter.
1
Make sure that you have booted the computer under DOS,
version 3.1 or later, and that your computer is connected
to the network, as detailed in Chapter 2, "Installing the
Adapter."
2
Insert the
EtherDisk
diskette in a floppy drive on your
computer and make that drive the current drive.
For example, if the diskette drive is A, type the following
command:
A: [Enter]
3 Type at the prompt:
AUTOLINK [Enter]
For configurations other than a single EtherLink III adapter in
a DOS ODI client environment, type:
INSTALL [Enter]