12
13
30%
30%
Check the following before switching on the unit for the first time:
•
That the unit is properly closed and all the outlets are connected to the ductwork.
•
That the electric connection matches the diagram, including earthing and protection of external circuits.
•
That all the electric components are properly connected.
•
That the condensate drain is connected to the sewage
•
That the installation corresponds to the instructions in the manual.
•
That no tools or objects that may damage the unit have been left inside.
•
That the filters are clean
ATTENTION!
•
Alterations and changes to the internal connections of the unit are forbidden and may result in the loss of warranty.
•
We recommend the use of accessories provided by our company. Contact your supplier in case of doubts with the use of non-original
accessories.
7. CONTROL
INITIAL COMMISSIONING
•
After connecting the unit, the display lights up and the data is
loaded. The service data begins to load. Once it has fully loaded,
the unit is ready for start-up.
•
The remote control has a touch-screen – the unit is controlled
touching the symbols on the screen.
Switching the unit to
stand-by mode
Activate boost mode
Unit's time switch
Displays current temperature, ventila-
tion rate, CO2 concentration, ventila-
tion date and mode
Ventilation rate settings
Required temperature
settings
Password lock
Detailed information
on ventilation status
Unit settings
Start-up:
INFORMATION ON THE VENTILATION
STATUS
Back
This screen shows the status of the unit and the values of the sen-
sors::
•
Current air flow of both fans
•
Inlet and exhaust air temperature
•
Status of the heat exchanger bypass
•
Performance of the electric preheating and reheating
•
Values of the connected air quality sensor
Information on
the type of unit
Occupancy mode active
Timer mode active
Heater cooling
in progress
