61
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Prefixlist 1–16
– call routing will obey the rules set in Prefix list 1–16. The
count of digits to be dialled is governed by the
setting.
Prefixes
All prefixes
– all the prefix lists are permitted. Prefix lists 1–16 will be
searched from 1 to 16. The first match will be used routing. For incoming
GSM calls, the Count of digits from the
GSM incoming group
parameter will be applied.
Count of digits
– all the prefixes are permitted. Routing is only limited by
the count of digits to be dialled.
Time limitation
– time validity limitation for a selected LCR row.
Weekend usage
– enable/disable a row on weekends.
Call duration limit
– set the maximum duration (minutes) for an outgoing call
to the GSM/UMTS network.
Groups
– define the outgoing GSM groups or interface via which outgoing calls
will be routed from
. If the defined interface is inactive or
2N
VoiceBlue Next
®
the outgoing GSM group tariff is exhausted, the next row will be applied.
GSM groups 1–4
– outgoing GSM groups. Set the tariff to be used. Refer
to the GSM outgoing groups subsection for details.
VoIP (V)
– VoIP interface. Refer to the
subsection for
VoIP parameters
details.
Tariffs
– select the tariff group (free minute counter) to be used for the outgoing
call. Refer to the GSM outgoing groups subsection for details.
Ignore tone detection in last group
– having detected a user defined tone
(refer to GSM basic settings), the GSM gateway automatically terminates the call
and seeks for another call setup way. If this parameter is activated, the GSM
gateway ignores the tone detection results and sets up a call when this is the
only possible call establishing way.
CLIP routing table + CallBack
The table permanently assigns CLIPs to the extensions to which incoming calls are to
be routed automatically and set the CLIP list for the GMS network for which the
CallBack function is enabled.
GSM number (CLIP)
– user Id in GSM/UMTS.
Used service
Autodial
– enable/disable CLIP routing for the selected CLIP.
Reject call
– reject call for the selected CLIP.
Ignore call
– ignore call for the selected CLIP.
Tone dial-in
– incoming GSM calls is ac dialtone is activated for
the selected CLIP.
DISA message dial-in
– incoming GSM calls is accepted + voice
message is activated for the selected CLIP.
Dial to VoIP
– VoIP destination number for the CLIP routing function.
Auto
CallBack
–
enable/disable
the
CallBack
function
for
the
selected CLIP according to the
Gateway configuration / GSM basic settings /
setting.
Calls / Source interface for CallBack
Note
If you use tariff routing, set the tariffs properly in the GSM outgoing
groups subsection.
The maximum count of LCR table records is 64.
The rules are applied to calls sequentially, starting from the first rule. If all
the set rules are met in a row, the call is routed according to the row.
Call routing from VoIP/VoIP is not supported. Such calls will be rejected
by
.
2N VoiceBlue Next
®
