2N 9137111CKU, Руководство по установке

Страница: 93 / 113

Installation manual 2N® IP Vario
93 / 113
•
•
•
•
Network parameter reset and DHCP switch are signaled by the sound.
For devices with FW versions 2.33 and lower, wait until the device is automatically
restarted.
After restart, the static IP address mode is switched into the dynamic IP address and
vice versa.
Simultaneously, all the System / Network parameters are reset to default values. This is
useful where it is impossible to connect to the device due to wrong VPN configuration, for
example.
Switching between static and dynamic IP address
The static IP address mode will be switched into the dynamic IP address mode and vice versa
upon restart.
3.2 Intercom Control as Viewed by External User
Quick Dialling Buttons
By pushing a quick dialling button on the basic unit you can call to positions 1, 3...6 of the
telephone directory (depending on the model type). With extending modules you can use up to
54 quick dialling options.
By pushing a quick dialling button you call the telephone number assigned to the selected
telephone directory position. A call set-up is signalled by a long discontinuous tone or any other
tone as defined in the attached PBX configuration.
•
Note
The 15 times 1 sequence must be entered within 30 seconds after the first sound
signal for security reasons. The inter-digit delay may be 2 s at most.
