68
People Counting
People counting is used to count people entering or leaving an area.
Only certain NVR models support this function. This function cannot be
used at the same time with other VCA functions (face detection,
intrusion detection, cross line detection, defocus detection and scene
change detection).
1.
Click
Alarm
>
People Counting
.
2.
Select the camera and then select
Enable Shoulder Demarcation
.
Draw a virtual line on the screen to set the minimum width of
detection. People narrower than the set width will be ignored.
3.
Click the
Draw
button and then draw rules on the left. Set entrance
direction and sensitivity as needed.
4.
By selecting
Enable Clear by Schedule
, you can have people
counting OSD reset at a specified time every day. You may also click
Clear Counting Result
to clear the OSD immediately. Resetting
people counting OSD only changes the OSD. It does not change
report statistics.
5.
Click
Apply
to save the settings.
Defocus Detection
Use defocus detection to check whether the camera focuses properly.
