Dokumenten - Nr.: MG_DKA50001
Änderungsindex: 00
Freigabedatum: 07.04.2005
U
U
U
Usssser
er
er
er Manual
Manual
Manual
Manual „„„„Keramikofen 1500“
Keramikofen 1500“
Keramikofen 1500“
Keramikofen 1500“
H:\Bestellblock, Gebrauchsanweisung, Broschüren, Plakate\Instruktionen, Bedienungsanleitungen\Bedienungsanleitung Sinterofen\MG_DKA50001_00
Ofenbedienung - englisch.doc
Seite 1 von 1
1.
1.
1.
1.
Activate the
Activate the
Activate the
Activate the furnace
furnace
furnace
furnace
Turn the main switch from „0 OFF“ to „1 ON“
Then select the requested program; program 1 is pre-selected. (To continue with the previously used
program, skip this step).
To select a program use the pushbutton
to access the program selection. Press the button several
times, until the display resembles the picture below (picture on the left shows that program 1 has
been selected).
Now use the up
and down
buttons, to select the requested program. Use the pushbutton
to
go back to the initial level.
To start the furnace with the selected program, press the green switch. If the furnace is working, the
green button is illuminated and the display shows the message "ZIRKONZAHN - Programm 1 running“
(e.g. if program 1 has been selected.) Furthermore, on the bottom of the display an orange RUN –
message is illuminated, indicating that the program is running.
2.
2.
2.
2.
Note
Note
Note
Notessss controller
controller
controller
controller
