Networking hole
Gas convection holes
Testing button
LED
QUICK INSTALLATION GUIDE
v1.0
SMART COMBUSTIBLE
GAS SENSOR
5. Semi-conductor of gas sensor has 5 year lifespan
6. Don’t use lighter to test the sensor directly
Liquefied petroleum gas should be isntalled at 0.3-1m
height from floor and semi-conductor of sensor installation
position to gas source should be less than 1.5m. Natural gas,
manufactured gas, marsh gas, etc. should be be installed at
0.3-1m bellow from ceiling, semi-diameter to gas source less
than 1.5m.
INSTALLATION
NETWORKING METHOD 1:
AD HOC NETWORK
Insert the sensor into socket and enter Ad-Hoc Network
condition.
INTRODUCTION
This Smart Combustible Gas Sensor adopts super low power
consumption ZigBee Wireless module. Used for detecting
combusting gas leakage and preventing danger caused by
gas leakage it also can be used as ZigBee repealer to extend
wireless transmission distance. It adopts high stability semi-
conductor gas sensor. Sensor alarms if gas density in air
exceeds set alarm level. It is applicable for kitchen or possible
gas leakage in in-door area.
OVERVIEW
TRADEMARKS
Zipato and the Zipato logo are registered Trademarks. All other
product names mentioned herein may be trademarks or
registered trademarks of their respective companies.
NOTICE
Although Zipato has attempted to ensure the accuracy of the
content of this manual, it is possible that this document may
contain technical inaccuracies, typographical, or other errors.
Zipato assumes no liability for any error in this publication, and for
damages, whether direct, indirect, incidental, and consequential
or otherwise, that may result from such error, including, but not
limited to loss of data or profits.
Zipato provides this publication “as is” without warranty of any
kind, either express or implied, including, but not limited to
implied warranties of merchantability or fitness for a particular
purpose. The published information in the manual is subject
to change without notice.Zipato reserves the right to make
changes in the product design, layout, and driver revisions without
notification to its users. This version of the Installation guide
supersedes all previous versions.
SPECIFICATION
Working voltage: AC100~240v
Avarage consumption: <1.5w
Alarm sound: 75Db (1m distance)
Alarm density: 6%LEL+3%LEL (natural gas)
Networking: Z-Wave Ad-hoc networking
Wireless distance: <100m (open area)
Working environment: -10°C~+50°C
Working humidity: 95%RH
Dimensions: 79 x 68 x 31 (without plug)
WARNINGS
1. Shell surface will be slightly hot while working, which is
normal phenomenon
2. Please dismantle sensor while decorating house
3. Avoid spraying aerosol around sensor
4. Oil adhension around gas convenction holes may effect the
senistivity of gas sensor after long time of use. It’s suggested
to clear gas convenction holes every 3 months (with little
detergent, but with care so it doesn’t enter the body of the
sensor).
