Boot/bonnet/door switches
Orange
Orange/white
Grey
Black
To starter solenoid
To ignition switch
Grey
Black
30
85
86
87A
87
OPTIONAL
Existing Low Current Solenoid
Feed Wire(+12VDC, Key
ON
Only
Brown
Siren
Green/black
Brake light
Foot brake switch
+12V DC
Orange/white
Ignition key
ON
Blue
Green
Brown/white
white
Yellow
Black
Red
FUSE 15A
BATTERY
DC 12V
White/yellow
Parking light
White/yellow
Shock Sensor
Red/green/black
Arm & Memory LED
Override Sw.
Antenna
Alarm receiver
1 2 3 4 5 6 7 8 9
10 11 12 13
CONNECTION DIAGRAM
CAR ALARM SYSTEM
OPERATING & INSTALLATION INSTRUCTIONS
HT-618
16.
17.TRANSMITTER LEARNING PROCESS
Method 1:
a)Turn the ignition key to ON & OFF 5 times continuously then stay ON . The status LED
will flash to indicate the transmitter can be learnt.
b)Press any button of the transmitter to be learnt once, the status LED will stop flashing and light
solid, press any button of the transmitter once again, the siren will chirp once, the LED will turn
off and indicate successful learning. The LED will flash again ready for the next learning.
c)Repeat the same procedure in step b) for the maximum learning of 6 transmitters. After
completed learning of each transmitter turn off the ignition key to exit the learning process.
Method 2:
Open the case of the alarm receiver, press the Learning Switch on the control module once, the
status LED will light solid, then press any button of the transmitter to be learnt once, the siren
will chirp once, the LED will turn off and indicate successful learning. Repeat the above
procedures for the maximum learning of 6 transmitters.
18.TO DELETE TRANSMITTERS FROM MEMORY
Method 1: Open the case of the alarm receiver, press and hold the Learning Switch on the control
module for 3 seconds, the siren will chirp twice and the parking lights will flash 8 times to
indicate the transmitters in memory have been erased.
Method 2: Turn the ignition key to ON & OFF 5 times then stay ON , the status LED will
flash, then press the Override Switch 5 times, the siren will chirp twice and the parking lights
will flash 8 times and indicate the transmitters in memory have been erased.
VALET MODE LED ON (SOLID)
This is for situation in which it is not convenient for the alarm to be armed, such as car wash. In
the valet mode all of the alarm ' s security features have been turned "OFF" and only the
convenience features such as keyless entry can be operated. To activate this function, turn "ON"
the ignition, press and hold the Override switch for 5 seconds, the status LED will remain on and
solid for as long as the system is in "Valet Mode". Repeat the above operation to exit valet mode,
the LED will turn "OFF".
"
"
"
"
"
"
"
"
"
"
"
"
The battery for the transmitter is 12V. Change the battery when LED becomes dimmer or
transmission takes place in a nearer distance.
Changing the battery:
a.Remove the screws of the transmitter and open the back lid.
b.Take out the original battery and remember the (+) positive & (-) negative side of the battery.
c.Put in the new battery (Model No:GP23A) correctly.
d.Put on the back lid and screw down the screws and remember not to destroy the switch or the
LED on the circuit board.
WARNING
