Technical Documentation
© Zennio Avance y Tecnología S.L. Edition 3 Further information
www.zennio.com
Page.
1
/
2
MAXinBOX66
MAXinBOX66. Multi-function actuator 6 outputs 16A and 6 A/D inputs
ZN1IO-MB66
Technical Documentation
FEATURES
DIN rail unit assembly (EN 50022), with snap fit clamp.
Size 67 x 90 x 80 mm (4.5 DIN units).
KNX BCU integrated.
3 different configurable channels
(
*
)
:
shutter channels (up to 3)
individual outputs (up to 6)
6 analog/digital inputs.
Manual output operation with push button and
LED status indicator.
Logical functions included.
Output timing facilities.
Total data saving on power failure.
Suitable for capacitive loads, maximum
140 µF
.
Possibility to connect different phases in adjoining
outputs.
CE directives compliant.
GENERAL SYSTEM SPECIFICATIONS
CONCEPT
DESCRIPTION
Type of device
Electric operation control device
KNX supply
Voltage
29VDC SELV
Voltage range
21
…31VDC
Power consumption
240 mW (max)
Bus connection
Typical bus connector TP1, 0.50 mm² section
External power supply
No
Ambient temperature
from 0ºC to +55ºC
Storage temperature
from -20ºC to +70ºC
Ambient humidity
30 to 85% RH (no condensation)
Storage humidity (relative)
30 to 85% RH (no condensation)
Complementary characteristics
Class B
Safety class
II
Operation type
Continuous operation
Device action type
Type 1
Electrical solicitations period
Long
Type of protection
IP20, clean environment
Assembly
Independent control assembly device to be mounted inside of electrical panels with
DIN rail (EN 50022).
KNX bus failure response
Data saving and relays open if channel configured as a shutter.
Response when restarting KNX bus
Data recovering and output status change according to programming when
recovering.
Operation indication
Programming LED indicates programming mode (red) and test mode (green). Output
status LED indicators reflect current output state.
Weight
200
gr.
PCB CTI index
175 V
Enclosure
PC+ABS FR V0 halogen free
Programming/test button
: short button press to set the programming mode. If this button is held while plugging the device into the KNX bus, it goes
into safe mode. If this button is held more than 3 seconds, the device goes into manual mode (test mode)
LED:
programming mode indicator (red). When the device goes into safe mode, it blinks (red) every half second. The manual mode is indicated by the
green color. During start up (after reset or power failure) and if the device is not in safe mode, LEDs indicators blink blue for a few seconds
1
. Analog/Digital inputs
2
. Upper outputs
3
. Output status LED indicator
4
. Output control button
5
. Programming/Test LED
6
. Lower outputs
7
. KNX connection
8
. Programming/Test button
4
1
7
8
3
5
6
2
Figure 1. MAXinBOX66
