Introduction
This Quick Start Guide applies to 2D
image readers. The varied models
include handheld, hands-free and
module. All models are capable of
decoding
1D
and
2D
barcode
symbologies.
The
scanner must
be
properly
powered before programming. During
the programming mode, the scanner
will acknowledge a good and valid
reading with a short beep. Otherwise,
the scanner will remain silent for
invalid scanning.
The barcodes herein only prepares
you ready to use the scanner. For
detailed programming instructions and
safety notices please refer to the
complete Programming Guide in the
manual CD.
If you can’t find the manual CD,
please contact your distributor.
Laser Safety
The devices using lasers comply with
US
21CFR1040.10
and 1040.11
except for deviations pursuant to
Laser Notice No. 50 dated July 26,
2002 and IEC608525-1:+A1:1997+
A2:2001.
The laser classification is marked on
one of the labels on the devices.
Avoid long term staring into direct
laser light to prevent damage to user
eyes.
Copyright © 2010 All rights reserved.
◎
◎
◎
◎
Default Factory Device Setting
Parameter
Default
-Level (for handheld/hands-free scanner)
Trigger Mode
-Presentation (for scan module)
Serial Host Type
SSI Host
USB Device Type
IBM Handheld USB
USB Country Keyboard Type
North American
* Level Mode
A trigger event activates decode processing,
which continues until the trigger event ends, a
valid decode, or the decode session time-out is
reached.
* Presentation Mode
When the device detects an object in its field of
view it triggers and attempts to decode.
1. Using Serial Interface
1.1 Serial Host
The default setting is SSI Host. If you use Serial Host, scan the Enable Serial Host
(No Variant) barcode at right before use.
If you use Serial Host, your RS232 software, such as Windows HyperTerminal,
can receive data from the scanner.
Enable Serial Host (No Variant)
1.2 Character Return
Scan the
<DATA> <SUFFIX 1> barcode at right to set up character return.
<DATA> <SUFFIX 1>
1.3 SSI Host
The default setting is SSI Host. If you use SSI host, your host device can transmit data
to software like Windows Notepad or Word. Follow the steps below to start using.
1. Connect the scanner serial cable to the host computer and connect a +5V power
adapter to the DC jack on the cable. The scanner would give a "Do Re Mi" melody
when powered on.
2. Read the SSI Host barcode at right to set up interface. (Skip this step if you are
using the default setting.)
3. Execute KeySimulator.exe in the Manual CD after the computer detects the
scanner.
4.
Choose a COM port number and click “Send Return” (Figure 1).
5.
Click “Start” to complete the setup procedure (Figure 1).
SSI Host
Figure 1
