1
Use PCtools to add the layout of "Adapter plug" with
preferred nomination, for example: Fan, then using
USB cable to connect PCtools and Smart remote
controller. Then long press the “SET” button of the
Smart remote controller to enter into the setting option.
After selecting “Data transmitting/importing”, please
press ”ON” button (or use Hotkey: SET + Up direction
button) as shown below to write the layout to the Smart
remote controller:
2
Confirm that the Adapter plug is not connected to
supply mains, and its indicator light should not be on
at this stage. First remove the USB cover by using
the plus screw driver, and the Micro-B receiving port
of Adapter plug could be found
；
Connect the Smart
remote controller (Type A transmitting terminal) and
the corresponding Adapter plug (Micro-B receiving
terminal) simultaneously using the USB cable as
shown below.
●
The product complies with NCC Administrative Regula-
tions on Low Power Radio Waves Radiated Devices
：
Article 12
：
Without permission granted by the NCC,
any company, enterprise, or user is not allowed to
change frequency, enhance transmitting power or alter
original characteristic as well as performance to an
approved low power radio-frequency devices.
Article 14
：
The low power radio-frequency devices
shall not influence aircraft security and interfere legal
communications; If found, the user shall cease operating
immediately until no interference is achieved.
The said legal communications means radio communi-
cations is operated in compliance with the Telecommu-
nications Act. The low power radio-frequency devices
must be susceptible with the interference from legal
communications or ISM radio wave radiated devices.
●
Indication of safety marks: If recommended precautions
and safe operating methods are not followed, physical
injury and damage of electrical appliances may be
caused.
Precautions for safe use
v��
Adapter Plug/RX15-3STS-1
User Guide/Warranty
Package contains
●
This product is for indoor use but not suitable for
outdoor use.
●
Please use this product in dry condition instead of
exposing it in beads of water or in high humidity.
●
Do not place this product near any equipment that
generates heat, such as heaters, electric heaters, gas
burners, or other heat-generating equipment.
●
Do not disassemble the Adapter plug yourself.
●
Do not use foreign objects to insert the Micro-B receiving
port of the Adapter plug.
●
Please place and fix the Adapter plug properly to avoid
damage by collision and dropping from high place.
●
Only one Adapter plug can be used for one circuit of the
Wall Outlet Socket. Neither the current loading over 15A
nor the power loading greater than 1,650W is allowed.
Connected or extended with other power strips for
extension is not allowed.
●
If the Adapter plug is damaged or deformed, the Adapter
plug should be replaced.
●
Do not use chemical/corrosive/solvent or bleach to clean
the Adapter plug as this may damage the housing of it.
Please wipe it with a dry and clean cloth.
Instructions of usage
Adapter Plug
Quick Instruction Manual
Components of Power Strip
Indicator light
Outlet socket
USB cover
Plug
PC-Tx Mode
Tx-Rx Mode
Tx-Tx TxSide
Tx-Tx RxSide
PC-Tx Mode
Import OK
Type-A-female connector
Micro-B connector
