background image

AERODYNAMIC ACCESSORIES

TORPEDO KOMPACT

TORPEDO KOMPACT

IMPORTANT:

PLEASE COMPLETELY UNDERSTAND ALL USER INSTRUCTIONS AND SAFETY INFORMATION BEFORE USING THIS PRODUCT.  AS WITH ANY HIGH TECH PRODUCT YOU 

WILL NEED TO ROUTINELY CHECK FOR LOOSE HARDWARE, CRACKS OR OTHER DAMAGE AND REPLACE ITEMS AS NECESSARY. 
DO NOT USE PRODUCT IF ANY OF THESE CONDITIONS EXIST.

The 

TORPEDO KOMPACT

 comes pre-assembled in the packaging so the only step needed is to adjust the clamp width to fit 

your aerobars. The 

KOMPACT

 comes assembled for bar extensions 85mm - 150mm center-to-center.

For aerobar extensions between 70 and 84mm center-to-center, the rear cage position must be used.  See section “Moving the Cage to 
the Rear Position” below for those steps. The computer mount is already assembled for Garmin Edge series. For Garmin Multisport 
watches see section 3.

1. TO MOUNT THE TORPEDO KOMPACT:

 1. 

Remove Aqua-Shot bottle

 from the cage by pulling directly forward.

 2. 

Undo the Velcro straps (A)

 on both mounting clamps.

 3. 

Loosen the clamp mounting screws (B)

 using the 3mm Hex L-Wrench.

 4. 

Mount the Torpedo Kompact

 on the aerobar extensions by pressing each of the 

 

    mounting clamps onto the extensions until they snap into place.  There should be 

 

    an audible “click” when they snap on.  The mount should be positioned as far back 

 

    on the aerobars as possible for optimal steering control. The 

TORPEDO KOMPACT

 

 

    will also mount on aerobars that angle inwards as the clamps can rotate to accommodate 

 

    the angle. 

 5. 

Center the mount

 between the extensions and make sure the bottle is pointed directly forward from the bike.

 6. 

Tighten the clamp mounting screws (B)

 to 35 in lbs (4.0 Nm) of torque. 

 7. 

Secure the Velcro straps (A)

 by routing underneath the extensions, up through the slot at the end of the clamp and back  

 

    down to attach the Velcro. Ensure the strap is tight enough so that the silicone underneath is firm against the extensions  

 

    (See ‘

Strap Routing Diagram

’).  Make sure to pull the strap as tight as you can so the mount doesn’t move.

 8. 

The mount is now secure

 and the bottle can be placed back in the cage.

A

B

C

D

E

Strap Routing Diagram

Computer 
Mount

Cage

Thin Black 
Spacer

Thick Silver 
Spacer

Strap

Plate

Clamp

Aerobar

Extension

Strap

MOUNT CLAMPS TO FLAT PLATE

MOUNT CAGE TO FLAT PLATE

COMPUTER MOUNT

M5 x 8mm Button Head 

M5 x 18mm Button Head

M5 Nylon Insert Lock Nut

Thick Silver Spacer

M4 x 10mm Flat Head 

M3 x 6mm Flat Head

Thin Black Spacer

Hardware

C

F

E

D

G

B

F

Mounting Clamp

TOOL REQUIRED

 

3mm Hex L-Wrench 
Torque Wrench up to 35 in lbs (4.0 Nm)

Reviews: