Crochet Hook Kit Sets Assembly Instructions
Required Accessories
• 7mm, Pen Mandrel
• 9.5mm Drill Bit RZ-DB3/8
• Barrel Trimmer
• 2 pcs Bushings Set RZ-PK285#-BU
• Glue (Thick CA or Epoxy)
Preparing the Blank
• Prepare and cut a blank of 3/4” or larger, to the length of the brass tube (add
1/16” for trimming)
• Drill a 9.5mm hole through the center of the blank.
• Spread glue over the tube, insert into blank with a twisting motion to spread
the glue evenly inside.
• Center the tube inside the blank.
• When glue is dry. Trim the ends of the blank flush to the tube.
Turning the Blank
• Place the bushings and blank on the mandrel according to Diagram B.
• Thread on the knurled nut and hand tighten to hold all items in place.
• Slide the tailstock to the mandrel shaft, (do not overtighten, it could damage
the mandrel) lock in place.
• Turn the handle ends down, flush with the bushings using the lathe tools,
gradually increasing the grades of sand paper.
• Finish the wood with friction polishing. .
Diagram A
