4x4 or 6x6 4K HDMI Matrix Switcher
with HDCP 2.2 Encryption
MX-0404-H2 | MX-0606-H2
Quickstart Guide
In the Box
1x MX-0404-H2 or MX-0606-H2 Matrix Switcher
1x Handheld IR Remote
1x IR Receiver (38kHz)
1x AC Power Cord with EU Plug
1x AC Power Cord with US Plug
1x AC Power Cord with UK Plug
1x USB to DB9 RS-232 Cable
2x Mounting Brackets
1x Quickstart Guide
Basic Wiring Diagram
KEY
HDMI
HDBaseT / Ethernet
IR / RS-232
Power
HDMI from
source
HDMI to
display
HDMI to
display
HDMI from
source
RS-232 to Control System
LAN
Cat5/5e/6
AC Mains
UHD Display
UHD Display
UHD Source
UHD Source
IR Receiver
IMPORTANT!
Do not connect or disconnect (hot plug) the HDMI connections while
the matrix is powered on. Doing so may cause damage to the units or
connected devices.
Additional Information
This Quickstart Guide provides the basic steps for the common uses of
this product. Refer to the Installation Guide and other documentation on
the product page for additional information.
Before Beginning
• WyreStorm recommends visiting the product page before installing
this product for updates to this Quickstart Guide as well as other
information about the product.
• Verify that all items are included in the packaging per the
In the Box
list.
Pre Wire
1. (Optional) If using IR receivers or an IR control system, run the wire
and terminate per the
IR Ext (Receiver) Wiring
section.
2. (Optional) If using RS-232 to control the matrix, run the wire and
terminate per the
RS-232 Wiring
section.
Installation
1. Connect an HDMI source to the
HDMI In
on the Matrix using an
HDMI cable from a high quality brand such as
WyreStorm Express
.
Repeat for additional HDMI sources.
2. Connect a display device to
Output 1
using an HDMI cable from
a high quality brand such as
WyreStorm Express
.
Repeat for
additional displays.
3. (Optional) Using the included IR receiver, connect the 3.5mm (1/8in)
stereo plug to the matrix
IR Ext
port. If using a control system,
connect an IR out port on the control system to the
IR Ext
port on
the matrix using the
WyreStorm CAB-IR-LINK
or the cable created
in
Pre Wire
step 1.
4. (Optional) Using the cable created in
Pre Wire
step 2, connect the
9-pin DB9 Female connector to the
RS-232
port on the matrix and
the opposite end to a port on a control system.
5. Connect the supplied AC power cord and power on the matrix.
6. Configure EDIDs per the
EDID Settings
section.
Copyright © 2015 WyreStorm Technologies |
wyrestorm.com
MX-0404-H2 | MX-0606-H2 Quickstart Guide | 160722
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
1 of 4
WyreStorm recommends reading through this document in its entirety to become familiar with the product’s features prior to starting the
installation process.
Pure HDMI 4x4 or 6x6 matrix switch with support for full 4K resolutions and HDCP 2.2.
