Whitecroft Lighting Limited
Burlington Street, Ashton -under-Lyne, Lancashire OL7 0AX
Tel44 (0)870 5 087 087 Facsimile: +44 (0)870 5 084 210
Registered No. 3848973 England
Registered Office:
As above
Cygnus SX
Installation Leaflet
June 2014 - Rev B
GENERAL INFORMATION
1)
A qualified electrician, in accordance with IEE wiring regulations, should carry out connection
to mains wiring.
2)
Ensure that the rated voltage and frequency requirements are compatible with the available
mains supply.
3)
Cleaning of reflectors and lenses should be carried out using clean, soft and lint free cloths
and anti-static cleaning fluid
4)
Do not carry out high voltage insulation test, i.e. 500/1000v this may damage internal
components.
5)
Make sure product is isolated before installation
.
6)
We recommend use of a high temperature Copper Paste on all screws that need to be
accessed during maintenance process, this will prolong the life of the fixings and reduce the
force required to remove the screws.
7)
Some luminaires installed in outdoor environments may experience a build-up of internal
condensation. This is due to a difference in temperature between inside and outside the
luminaire which is quite common and acceptable under BSEN60598.
-
fig 12
TECHNICAL SUPPORT
Tel: 0161 331 5700
E-mail:
www.whitecroftlighting.com
GENERAL MAINTENANCE
To access the inside of the luminaire you will need to remove the 3 size 4 allen key
screws located on the top of the luminaire. Undo the screws at bottom of reflector and
remove to gain access to the gear tray. Then reverse the process to put cover back.
PK/LEAF/CYGNSX
