WattBox WB-ACC-TRIGGER Install Manual Download

Page: 1 / 2

INSTALL GUIDE

WB-ACC-TRIGGER

The WattBox Trigger provides users with an easy way to cycle power on any or

all of the outlets on a WB-IP device.

Package Contents

• WattBox Trigger (normally open, momentary closed) switch with adhesive

backing

• Capacitor (buffers the system against stray signals that create a false trigger)

Installation

If your WattBox unit has a service tag (S/T) that ends with the letter “A,” attach the

leads from the included capacitor to the leads from the trigger.
Position the switch in the desired location, then connect to the “REMOTE

TRIGGER” port on the WattBox using the phoenix connector included with the

IP device. Then log into the WB-IP interface to enable the trigger port and select

which outlets to power cycle.

Remote trigger

on the WattBox

Phoenix

connector

Capacitor

Extend wiring

up to 45'/13.7m

using Cat5 or other

conductors 24AWG

or larger. Wires can

be connected either

way (no polarity).

Summary of Contents for WB-ACC-TRIGGER

Page 1: ...e tag S T that ends with the letter A attach the leads from the included capacitor to the leads from the trigger Position the switch in the desired location then connect to the REMOTE TRIGGER port on...

Page 2: ...al conditions of use This warranty shall not apply to products which have been abused modified disassembled or improperly installed Products to be repaired under this warranty must be returned to Watt...