1
INSTRUCTION GUIDE: ZONESTAT AND SENSORSTAT
IG1603EW 10/12
997-012330-2-R Rev B
Instruction Guide:
IntelliZone2 ZoneStat and SensorStat
ZoneStat Installation Instructions
1.
Remove the cover from the ZoneStat and attach the
backplate to the wall making sure the thermostat is level.
2.
Connect 4 conductor (minimum 18 gauge) wire from the
ZoneStat to IntelliZone2.
3.
Zone ID must be set for each Zone (2-6) using the DIP
switches on the PCB. See the Zone ID Codes illustration
for configuration options. Zone ID can be confirmed on the
ZoneStat by pressing the cancel button for 5 seconds.
4.
Seal the hole in the wall to prevent air leaks and replace the
front cover.
IntelliZone2 ZoneStat
IntelliZone2 SensorStat
SensorStat Installation Instructions
1.
Remove the cover from the SensorStat and attach the
backplate to the wall in one of the two orientations shown
below.
2.
Connect 4 conductor (minimum 18 gauge) wire from the
SensorStat to IntelliZone2.
3.
Zone ID must be set for each Zone (2-6) using the DIP
switches on the PCB. See the Zone ID Codes illustration for
configuration options.
4.
Seal the hole in the wall to prevent air leaks and replace the
front cover.
A+
R
C
B-
P14 – Zone 4
A+
R
C
B-
P15 – Zone 5
A+
R
C
B-
Zone 3 Stat
On
3
2
1
Zone 4 code shown
A+
R
C
B-
Zone 5 Stat
On
3
2
1
Zone 5 code shown
ZoneStat
SensorStat
Zone ID must be set for each Zone 2-6. ID can be
confirmed on ZoneStat by pressing cancel button for
5 sec. ID shown on display. See Zone ID Codes.
Zone ID must be set for each Zone 2-6. ID cannot be
confirmed on Zone SensorStat. See Zone ID Codes.
IntelliZone2
Relay Board
On
3
2
1
On
3
2
1
On
3
2
1
Zone 4
Zone 5
Zone 3
On
3
2
1
Zone 2
On
3
2
1
Zone 6
Zone ID Codes
NOTES:
1) Zone ID must be set for each Zone 2-6. ID can be confirmed on ZoneStat
by pressing cancel button for 5 sec. ID shown on display.
2) Small screw driver can be used to set ID thru protective plastic skin!
3) MasterStat always Zone 1. Zone ID not necessary.
NOTE:
The SensorStat must be installed in one of the two orientations
shown above for the most accurate temperature sensing.
SensorStat Board
UP
SensorStat Installation Orientation
