![background image](http://html1.mh-extra.com/html/vision/trimax-carbon-si/trimax-carbon-si_installation-instructions_1031130001.webp)
TriMax Carbon Si Installation Instructions
Published
–
Jul, 2021. ZS208B.v1
©
Full Speed Ahead
Introduction
Congratulations on your Vision product. Please read these instructions and follow them for correct use. Failure to follow the
warnings and instructions could result in damage to product not covered under warranty, damage to bicycle; or cause an accident
resulting in injury or death. Since specific tools and experience are necessary for proper installation, it is recommended that the
product be installed by a qualified bicycle technician. FSA & Vision assumes no responsibility for damages or injury related to
improperly installed components.
Warranty
Full Speed Ahead (FSA) warrants all FSA and Vision products to be free from defects in materials or workmanship for a period of
two years after original purchase unless otherwise stated in the full warranty policy. The warranty is non-transferable and valid to
the original purchaser of the product only. Any attempt to modify the product in any way such as drilling, grinding, and painting will
void the warranty. For more information on warranty policy and instructions for completing a warranty claim, check out the Full
Warranty Policy found at our website:https://www.visiontechusa.com/en/technology
Always use a calibrated torque wrench to tighten all screws and bolts when assembling and adjusting the vision
handlebar to the bicycle. Failure to use a calibrated torque wrench can cause damage to the handlebar making it unsafe to ride and
is not covered under warranty. Check bolt and screw torque before each ride to ensure they have not loosened during use.
Periodically inspect your Aerboars for any cracks, chips, scratches, and any other visible damage. In the event of an
accident do not ride the bicycle until the handlebars have been inspected by an experienced mechanic as the aerobars may be
damaged or weakened even if no visible damage is apparent. If there is any visible damage, the aerobars should not be used any
further and replaced.
When changing the Armrest Stack spacers
④
,
⑤
,
⑥
, use the correct length bolt
②
as per the chart show in Table 1.
Use only FSA supplied bolts. Failure to use the correct length bolt can result in thread strippage of the base bar, failure of base bar,
and armrest pad and can cause serious accident or injury.
Specification
These instructions are for the installation and adjustment of the following Vision Brand components only:
Model Name
TriMax Carbon Si
Components
Follow the assembly order in the illustration:
①
TriMax Carbon SI Base Bar x1
Extension Width Spacer Bolts x4
②
③
Bottom Cover x2
Armrest Stack Spacers (20mm) x6 (AM)
④
Armrest Stack Spacers (10mm) x2 (AM)
⑤
Armrest Stack Spacers (5mm) x2 (AM)
⑥
Lower Angle Adjustment Bracket x2
⑦
⑧
Angle Adjustment Grip Nut x2
⑨
Upper Angle Adjustment Bracket x2
⑩
Bridge x1
⑪
Aero Extension (Left & Right) x2
⑫
Aero Extension Front Plug x2
⑬
Aero Extension Rear Plug x2
Angle Adjustment Bolt (M7x19mm) x2
⑭
⑮
Extension Fixing Bolts (M5x15mm) x2
⑯
Armrest Pad (Left & Right) x2
Armrest Plate Fixing Bolts (M5x10mm) x4
⑰
Armrest Pad Plate (Left & Right)
⑱
x2
⑲
Extension Bridge x1
Fig.1