2
3
4
5
6
7
1
Installation
2012.09.01 12:00:00
User Manual
Ver. VD-9000FHD 1.0 E
www.visiondrive.co.kr
Do not disassemble or remodel this product as it can cause an electric shock.
Only use adaptors with the appropriate specifications.
Do not disassemble the product.
When installing the device to your vehicle, follow all the procedures and make sure the
mount is secure.
Unclean surfaces will weaken the adhesive strength and can damage the product if it
drops due to weak adhesion.
This product is not waterproof. Do not allow liquids and impurities to enter the product.
Where the product is wired to the power supply of the vehicle directly or if the cigar
jack is connected to the power supply while the engine is off, make sure to disconnect
the device to prevent battery drain on your vehicle.
Do not use chemicals or detergents to clean the device. This can result in malfunctioning
of the product.
Caution
!
Connect the bracket and the unit
Connect the attachment bracket with the main unit and push it to the
direction 1 to secure the lock to hear the click sound.
Insert SD card into the unit
Connect cable and attach on windshield
Clean the area on the windshield where the unit will be installed.
For the placement of the unit, it is better to place the unit closer to the
center of the vehicle.
Connect to power source to turn on the unit
Insert the cigarette jack into an appropriate outlet then turn on the engine.
Check LED lamps
The REC lamp is blue when it is recording. It is blue when it is recording a
(NORMAL) file and red when recording an (EVENT) file after an impact or if
the SHOT button has been pressed.
The GPS lamp is red when the GPS signal is not received and blue when it is
received. The GPS connection may take a couple of seconds to several
minutes, depending on the location of your vehicle.
Adjust the camera angle
Move the camera top to bottom to fix it to a recordable position while
checking the LCD
Arranging wires
Use the enclosed wire holders to organize the cable line.
