![background image](http://html.mh-extra.com/html/vinylworks/orgpp2/orgpp2_safety-and-installation-instructions_1028791001.webp)
POOL ORGANIZER LIGHT
POOL ORGANIZER LIGHT
POOL ORGANIZER LIGHT
POOL ORGANIZER LIGHT
( Model ORGPP2)
( Model ORGPP2)
( Model ORGPP2)
( Model ORGPP2)
1. Before starting installation, remove
Pool Organizer from pool (if assembled /
installed already). Fit cord of light through
light bracket, front to back (Detail 1.1). The
bracket has two small notches (Detail 1.2-
1.4), the cord fits into the top notch. Place
bracket with light against connector plate
& attach using 2 short bolts at the lower
holes (Detail 1.5 & 1.6).
FRONT
BACK
Detail 1.1
Detail 1.5
Detail 1.2
Detail 1.4
Detail 1.3
Detail 1.6
2. Position & attach drink tray over the light bracket &
secure using the two long bolts provided (Detail 2.1). Note
that the long bolts pass through drink tray & light bracket
and thread into connector plate. Tighten all hardware.
Detail 2.1
Detail 3.1
3. Pass cord up
behind
bracket
neatly & under
base
connector
of pool organizer
(Detail 3.1)
4. Insert light cord into transformer & thread tight
(Detail 4.1). The transformer plug MUST be plugged
into a 110V GFCI receptacle (see above safety
information). NEVER USE AN EXTENSION CORD.
The receptacle must be enclosed & weatherproof &
at least 1 foot above ground surface
IMPORTANT SAFETY & INSTALLATION INFORMATION
•
This product meets or exceeds applicable standards established by Underwriters
Laboratories (UL listed) - see back page, Details 5.1 & 5.2
•
Install to / plug into only a 110V receptacle protected by a ground fault circuit
interrupter (GFCI). The GFCI should be enclosed and weatherproof and at least 1 foot
above ground surface
•
Always remove plug from receptacle before installing, winterizing or servicing light
•
DO NOT USE EXTENSION CORDS - DEATH OR INJURY CAN RESULT
•
This product is designed and intended for use as an underwater light in an above-
ground pool; never modify or use for any other purpose, serious injury can result
•
Light fixture MUST be submerged in water before plugging in / illuminating
GFCI
Detail 4.1
LIGHT FIXTURE MUST BE SUBMERGED IN WATER
BEFORE PLUGGING IN & ILLUMINATING