2.
Attach racks to frame
- Using two 3 bottle deep base cradling
racks, and starting with the bottom three cross rails at the left side
of the assembled frame, align the mounting holes in the racks with
the holes on crossrails. Temporarily place alignment tool through
center hole in first rack, crossrail and the center hole in second
rack, as shown. Attach racks to crossrails as shown. After securing
top and bottom of racks, remove alignment tool and replace with
assembly screw. Repeat for each rack set, alternating between
base and neck sets. Then, move on to the upper three crossrails
and install the 2 bottle deep racks in the same fashion.
1.
Assemble frame
- Insert and hold a footer pad nut inside the tube,
aligned with the pre-drilled hole, and thread the footer pad into the
nut. Tighten all of the footer pads with a 14mm wrench. Lay down
one upright and attach all six crossrails using the provided crossrail
assembly screws in the predrilled mounting holes noted below. Do not
fully tighten at this point to allow for adjustments during assembly.
Stand up the first upright and attach the second upright to crossrails.
†
IDR Extension packages contain only 1/2 the quantity of noted items.
Hardware shown
actual size
6 X
WS33
4 X
†
Footer Pad
6 X
IDR-CR3
1 X
IDR-PR
2 X
†
IDR7-UPRIGHT
24 X
Crossrail Assembly
Screw
3 X
IDR-PR Assembly
Screws
36 X
WS Assembly
Screw
2 X
†
IDR-PR Assembly Bolt
4 X
†
IDR-PR Assembly
Washer
6 X
WS32
Footer
Pad Nut
4 X
†
Attach
Crossr
ails Here
Attach
Crossr
ails Here
Required tools: 2 X 14mm (or adjustable) Wrench
Electric Screw Driver with #2 Phillips Bit
IDR-AK - included with IDR and contains an
8mm Nut Driver and Alignment Tool
7’ Island Display Rack (IDR7) Assembly Instructions
Wine Master Cellars, LLLP • 10645 E 47th Ave, Denver, CO 80239 • phone: 866.650.1500 • fax: 866.650.1501 • VintageView.com
