PRODUCT MANUAL
Designed, Manufactured and Supported in the USA
C O M M U N I C A T I O N & S E C U R I T Y S O L U T I O N S
Interface Your Voice Paging System with
Virtually Any Telecom or IP Phone System
Features
• Select:
FXO
(loop start),
FXS
(ring trip) or paging port
(
VOX
relay) interface mode
• No power supply required in FXS interface mode
• Up to 6 units can be powered from one adapter in the
FXO
or
VOX
mode
• 30V DC talk battery for interfacing with
FXO
or unused
phone system line input/trunk port
• Floating 600 ohm paging output with volume control
• Normally open or closed relay for external paging amp
activation or interfacing the paging amp with an
external background music source
• 800 Hz pre-page page tone (on/off)
• Compatible with 24 to 48 volt
FXS
operation
• Calling party control (
CPC
) detection for immediate
disconnect
• Busy signal detect disconnect
• 2.5 second
VOX
silence disconnect timer
• Programmable
VOX
trigger sensitivity
• Disconnect timer: 16, 36, 60 seconds or disabled
• Screw terminal block connections
• Wall mount housing: (2) #6x3/4 panhead screws
included
• Integrate your paging system with virtually any POTS,
Centrex, Digital or IP phone system
• Suppress background music during paging
• Provides contact closure to activate paging system if
not provided by the phone system
• Add pre-page tone to your paging system
FXI-1
FXO / FXS / Telecom
Smart Paging Interface
December 15, 2015
Applications
Specifications
VIKING
Viking’s
FXI-1
universal paging interface allows you to provide paging
from virtually any type of phone system instead of from a microphone.
You can also provide background music and electronic night bell over
the audio system.
The
FXI-1
provides 30V talk battery for interfacing with an
FXO
or
unused analog line input/trunk port. With the flip of a switch, the unit
can connect to a
FXS
or
PABX
station ring trip port.
No power
supply is required in this mode.
In the event that it must be
connected to a “dry” 600 ohm paging port, the built-in voice activation
(
VOX
) is in control. This configuration is useful when interfacing with
systems that do not provide a paging contact closure, such as
Panasonic, South Western Bell, Intertel, etc.
In all modes the
FXI-1
provides normally open or normally closed
relay contacts to activate the central paging amplifier equipment or
connect to an external background music source. After paging, the
FXI-1
auto disconnects on
CPC
, busy signal, silence or default
disconnect timer. An electronic night bell over paging feature can be
activated from a momentary phone system contact closure (
FXO
and
page port mode only).
Power:
12-24V DC @ 100mA, 120V AC/12V DC @
500mA, UL listed adapter included (not required in
FXS
mode)
Dimensions:
111mm x 76mm x 36mm (4.38” x 2.97” x
1.38”)
Shipping Weight:
.48 kg (1.06 lbs)
Environmental:
0°C to 32°C (32°F to 90°F) with 5% to
95% non-condensing humidity
Relay Contacts:
30V DC@1A, 110V [email protected], 125V
VOX Minimum Audio Signal to Activate Relay:
-28dbm
minimum / -25dbm minimum @ 1KHz with VOX
sensitivity switch at normal / lower positions
VOX Time Out Disconnect:
2.5 seconds
Default Time Out Disconnect:
16, 36, 60 seconds or
disabled
Talk Battery:
30V DC
www.vikingelectronics.com
Information: (715) 386-8861
