1
PSM-29ZW / PSS-29ZW
Power Switch Series
Introduction
The Power Switch series include the following models:
PSS-29ZW:
Z-Wave Power Switch with Router function
PSM-29ZW:
Z-Wave Power Switch with Meter function and Router function
The Power Switches are capable of receiving wireless signals from the coordinator in the Z-Wave network to toggle
On/Off of appliances that are attached to it.
The Power Switch is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network.
Z-Wave is a wireless communication protocol that uses a low-power RF radio. By taking advantage of the Z-Wave mesh
network, commands can be transmitted to their destination via intermediary “listening” Z-Wave products.
The Power Switch with Meter function (PSM-29ZW) has the extra feature of keeping tracks of energy consumption with
built-in power meter and transmitting the data to coordinator regularly.
The Power Switch also serves as a router in the Z-Wave network. After being included in the Z-Wave network, it allows
other Z-Wave device to join the network through the Power Switch.
Parts Identification
1. Function Button aka LED indicator
The Function Button also doubles as the LED Indicator. The Function Button is used
to control the Power Switch. The LED indicator is used to indicate Power Switch
status.
LED Indication:
The LED indicator lights up in the following conditions:
- On: power on
- Off: power off
- Red light flashes twice:
1. The Power Switch has just been powered on.
2. The Power Switch has just been factory reset.
Function Button Usage:
- Press the Function Button to switch on/off the Power Switch.
- Press the Function Button 3 times within 1.5 seconds to transmit a learn code.
- Press and hold the Function Button for 10 seconds to factory reset.
Type F
Type J
Type B
Type E
Type G
Features
Adding Device (Inclusion)
This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other
manufactures and/or other applications. All non-battery operated nodes within the network will act as repeaters
regardless of vendor to increase reliability of the network.
Plug the Power Switch into a power outlet.
Put the Z-Wave Gateway or Control Panel into
Inclusion
mode
(please refer to the Z-Wave Gateway or Control
Panel manual).
Within 1.5 seconds, press the Function Button 3 times.
Refer to the operation manual of the Z-Wave Gateway or Control Panel to complete the adding process.
If the device has already been added (included) into another Z-Wave Gateway/Control Panel, or if the device is
